1 . Note: The appropriate personal protective equipment PPE, such as goggles and gloves should be used. Open flat stone cage placed on a hard , flat surface. Fold open all panels and eliminate flat .
2 . Fold down the side to meet endpanels. Cages each panel edge , around a thicker wire . These thicker wires should be twisted together into panels corners meet . Then strung together on both sides of the panel inlaid continuous length of wire .
Tip: Use Steele by tying wire saw cutting once. This will give you the tying wire length 1m feasible.
This is essential when the adjacent shoelace tying wire mesh panels along the length of continuous use is not a single twisted relationship .
3 . Lace panels together using approx. 1 meter length of tying wire thicker top line fixed end , and then in the same round , dual transfer mode, repeated every 100 mm mesh lace. Tug tying wire in gold and silver , to ensure a good tight seam .
4 . Once you have a right to run empty gabion together side by side , lace front and back joints along the empty cage . Gabion fill end portion , 1/ 3 height and within a simple "H" -shaped wooden frame and the other end to apply a tension load baskets , cages until taut . Maintain this tension until the gabions are filled .
5. Use double bar filling gabion baskets tying the wire inside the establishment of cross- relationships . These should be at a height and vertical 1/ 3 and 2 /3 of the level of 330 mm each . Zhasi stop bulging face.