Gabion installation process should note the following:
1. The cage mesh sewn furnishings wrong place , avoid longitudinal slit through ; quadrilateral mesh cage when erect , with the adjacent edge of the locking cable tie , tied lock , the tie -line border around the two overlap ( suture edges ) or borders and double kink cage side ( suture grille ) tightening spiral , galvanized avoid heavy damage , the pitch is not greater than 50 mm; gabion wire can be galvanized or coated with PVC mesh series was bigger, more coarse wire used . Lead wire with a thicker around the edges , with the closing of the top of each cage tied together like lashing lead the cage should be at least as durable. If each part lashing appropriate , you can increase the stability of the structure. There are many ways to close the edge of the grid , the screen only if the lead edge of the cage without weaving hook edge of the cage , which is easy to loose. Mesh galvanized after welding unless otherwise woven mesh better than welding . System with a large steel mesh cage (height more than 1 meter ) can be welded .
2. In order to adapt to the shape of the stone must be cut off gabions should be taken to ensure that the re- banding of gabion truncated and no truncation of the same firm .
3.When finished in the bottom surface of the mounting gabion online application tie line along the lower border of the newly installed cage will be fixed on the bottom of the cage , with a layer of neighboring cage also used to tie line fastened to each other , so cage fused ; in the same horizontal layer of a unit construction project should be in place before starting the whole cage filled with pebbles , in order to prevent deformation cage , two adjacent cage ( including cage with the same network o geocell ) of rock fill height should not exceed 35 cm;
4.gabions stone fill within the network after coming under roof cover , and then tie the line to the border of the two coincide tightening spiral pitch should not exceed 50 mm. In masonry good online shop filled gabion 10 ~ 15 cm of humus for vegetation growth .
5. In addition gabions cage before installation , slope and ground should be properly trimmed , and tried to keep the original shape of the slope , but should not have a significant uplift and depression ; filled pebble select the floodplain , the compressive strength shall meet the design requirements , pebble grain size should be between 8 ~ 20 cm, and with a reasonable size required to meet the design requirements of the void and ensure network gabion straight appearance ; while filling gabion pebbles in the outer appearance application of particle size not less than 10 cm of gravel and artificial leveling pendulum puzzle to get beautiful surface and prevent water from mesh scouring the gravel walk . Should ensure ultra rockfill 2 5 ~ 3 cm high , in order to leave room for the settlement ; . Within gabion cages ( lead wire cage ) is usually placed on the periphery of the stones will be better to avoid low-quality stones filling the center , because it , bad shape gabion stones may squeeze through the surface , then water washed away. Once the stones were washed away , and the rest of the stones will become loose , causing friction and wear each lead wire .
Therefore , although usually not required to have all use a good stone, but the stone should be tight squeeze in gabion cages.